RELM PM4500 Instrukcja Obsługi Pobierz pdf (Strona 15)

If the data to be duplicated (cloned) is NOT already

in a Transceiver, proceed as follows:

1. Connect the PM4500 to the Transceiver to be

programmed using proper Start-up procedure.

2. Enter the data into the transceiver by using the

PM4500 normal programming functions.

Press CLONE.

If “READ?” is in the display, press ENTER. If

not, press CLONE again and then ENTER.

This will copy the Transceiver’s entire data into

the Programmer’s memory.

4. Turn OFF the Transceiver and then disconnect

the PM4500.

5. Connect the PM4500 to a Transceiver to be

cloned, using proper Start-up procedure.

6. Press CLONE (“WRITE?” must be in the dis-

play) and then ENTER.

7. Repeat steps 4, 5 and 6 for all other Transceiv-

ers to be cloned.

A detailed description of the CLONE (READ and

WRITE) operations follows:

TRANSFERRING DATA

MT0

THE

PROGRAMMER (READ OPERATION)

Press CLONE.

Disolav will show:

NOTE: If not,

pr::iztNE<n.

]

2. Press ENTER (to answer Yes).

Processing will begin. During data transfer, the

display will show:

3. When transfer is complete, the display will

show:

m!iibiw

TRANSFERRING

DATA

/NT0

THE

TRANSCEIVER ( WRlTE OPERATION)

1. Press CLONE. Display will show:

Blinking

NOTE: If not, press CLONE again.

2. Press ENTER (to answer Yes).

Processing will begin. During data transfer, the

display will show:

NOTE: If you attempt to transfer SM (for example)

Series data in the Programmer to a different series

Radio (such as PT, RSP, etc.), the display will

show:

The Transceiver will emit a series of beeps and

no transfer will take place.

3. When transfer is complete, the display will show:

1 2 ... 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

RELM PM4500 Instrukcja Obsługi Strona 15

Komentarze do niniejszej Instrukcji